شفرات منشار دقيق 24 سنًا لكل بوصة

Was hesitant about the soft metal backer flexing, but it holds firm and the 24 tpi edge is so fine it glides through balsa without any tear-out. Swapped it into my K5 and it fits perfectly, sharp as a fresh x-acto.

The 24 teeth per inch cut through acrylic sheet like butter with almost no chipping, which surprised me for such a fine blade. I was worried the soft metal backer would bend, but it stays rigid in my K5 handle.

I’ve been using these with my K5 pull saw, and the 24 teeth per inch cut through hardwood trim so cleanly I barely had to sand the edges afterwards. The hardened steel blade holds up much better than the cheap ones I used before.